Tree Pruning Services

Specific types of pruning may be necessary to maintain a mature tree in a healthy, safe, and attractive condition.
 
Cleaning is the removal of dead, dying, diseased, weakly attached, and low-vigor branches from the crown of a tree.
 
Thinning is selective branch removal to improve structure and to increase light penetration and air movement through the crown. Proper thinning opens the foliage of a tree, reduces weight on heavy limbs, and helps retain the tree’s natural shape.
 
Raising removes the lower branches from a tree to provide clearance for buildings, vehicles, pedestrians, and vistas.
 
Reduction reduces the size of a tree, often for utility line clearance. Reducing a tree’s height or spread is best accomplished by pruning back the leaders and branch terminals to secondary branches that are large enough to assume the terminal roles (at least one-third the diameter of the cut stem). Compared to topping, reduction helps maintain the form and structural integrity of the tree.

Pruning cuts should be made just outside the branch collar. The branch collar contains trunk or parent branch tissue and should not be damaged or removed. If the trunk collar has grown out on a dead limb to be removed, make the cut just beyond the collar. Do not cut the collar.
 
If a large limb is to be removed, its weight should first be reduced. This is done by making an undercut about 12 to 18 inches (30 to 46 cm) from the limb’s point of attachment. Make a second cut from the top, directly above or a few inches farther out on the limb. Doing so removes the limb, leaving the 12- to 18-inch (30- to 46-cm) stub. Remove the stub by cutting back to the branch collar. This technique reduces the possibility of tearing the bark.

Pruning cut location is critical to a tree’s growth and wound closure response. Make pruning cuts just outside the branch collar to avoid damaging the trunk and compromising wound responses. Improper pruning cuts may lead to permanent internal decay.
 
If a large branch must be shortened, prune it back to a secondary branch or a bud. Cuts made between buds or branches may lead to stem decay, sprout production, and misdirected growth.

Research has shown that dressings do not reduce decay or speed wound closure, and rarely prevent insect or disease infestations. Most experts recommend that wound dressings not be used.

For most young trees, maintain a single dominant leader growing upward. Do not prune back the tip of this leader or allow secondary branches to outgrow the main leader. Sometimes, a tree will develop double leaders known as codominant stems. Codominant stems can lead to structural weaknesses, so it is best to remove or shorten one of the stems while the tree is young.
 
A tree’s secondary branches contribute to the development of a sturdy, well-tapered trunk. When numerous branches are being removed, it is preferable to retain some, at least temporarily, to promote trunk diameter growth.

Most of the branches present on a young tree at planting will be pruned away at maturity to provide clearance for mowing, pedestrians, and / or vehicle traffic.
 
The height of the lowest permanent branch is determined by the tree’s intended function and location in the landscape. The road side of a street tree may be raised to 16 feet (5 m) to accommodate traffic. In most other situations, 8 feet (2.4 m) of clearance is sufficient. Trees used as screens or wind breaks, however, usually branch low to the ground.
 
Sufficient branch spacing and balance, both vertically and radially, is important. The space between permanent branches should be approximately 3 percent of the tree’s eventual height (for example, 1.5 feet [0.5 m] for a tree that can grow to be 50 feet [15 m] tall).
 
Beyond spacing, the strength of branch structure depends on the relative size of the branches and branch angles. Branches similar in diameter to the trunk or limb from which they arise are more prone to failure than those smaller in diameter.
 
Narrow angles of attachment or tight crotching can enclose bark within a branch union. Such growth is called included bark, a condition that weakens the branch attachment and may lead to failure when the tree matures. Branches with weak attachments should be pruned while still small. Balance should be considered by retaining some branches in each direction radially, spreading from the center outward. Make sure one scaffold branch is not allowed to grow directly above another.
 
When pruning, be sure not to remove too many branches. Leaves and their supporting branches are major sites of food production and storage. Eliminating too much of the canopy can “starve” the tree, reduce growth, and increase stress. No more than 25 percent of the crown should be removed in one pruning.

Tree pruning promotes healthy growth by removing dead, diseased, or overcrowded branches. It improves the tree’s structure, reduces the risk of falling limbs, and enhances its overall appearance.

Because each cut has the potential to change the growth of the tree, no branch should be removed without a reason. Common reasons for pruning are to remove dead branches, to improve form, and to reduce risk. Treesmay also be pruned to increase light and air penetration to the inside of the tree’s crown or to the landscape below. In most cases, mature trees are pruned as corrective or preventive measures.

Routine thinning does not necessarily improve the health of a tree. Trees produce a dense crown of leaves to manufacture the sugar used as energy for growth and development. Removal of foliage through pruning can reduce growth and stored energy reserves. Heavy pruning can be a significant health stress for the tree.

There are many outside considerations, however, that make it necessary to prune trees. Safety, clearance, and compatibility with other components of a landscape are all major concerns. Proper pruning, with an understanding of tree biology, can maintain good tree health and structure while enhancing the aesthetic and economic values of our landscapes.

The best time for pruning depends on the tree species. Generally, late winter or early spring is ideal before new growth begins. However, specific trees may benefit from pruning at different times of the year.

Most routine pruning to remove weak, diseased, or dead limbs can be accomplished at any time during the year with little effect on the tree. As a rule, growth and wound closure are maximized if pruning takes place before the spring growth flush. Some trees, such as maples and birches, tend to “bleed” if pruned early in the spring. It may be unsightly, but it is of little consequence to the tree.
 
A few tree diseases, such as oak wilt, can be spread when pruning wounds provide access to pathogens (disease-causing agents). Susceptible trees should not be pruned during active transmission periods.
 
Heavy pruning of live tissue just after the spring growth flush should be avoided, especially on weak trees. At that time, trees have just expended a great deal of energy to produce foliage and early shoot growth. Removal of a large percentage of foliage at that time can stress the tree.

Most trees should be pruned every 3-5 years, but the frequency depends on the tree’s age, species, and condition. Younger trees may require more frequent pruning to establish a strong structure.

Pruning focuses on removing dead or diseased branches to promote tree health, while trimming is primarily for aesthetic purposes, such as shaping hedges or improving a tree’s appearance.

Improper pruning, such as cutting too close to the trunk or removing too many branches, can harm a tree by making it vulnerable to pests, disease, and structural weakness. Hiring a professional ensures the tree is pruned correctly and safely.

Professional arborists have the knowledge and tools to prune trees safely and effectively. They ensure the tree’s health and safety while reducing the risk of property damage or injury. Let us handle your pruning needs with precision and care!

The amount of live tissue that should be removed depends on the tree’s size, species, and age, as well as the pruning objectives. Younger trees tolerate the removal of a higher percentage of living tissue better than mature trees do. Generally, no more than 25% of the crown should be removed at once, and less for mature trees.
 
Removing even a single, large-diameter limb can result in significant canopy loss and can create a wound that the tree may not be able to close. Care should be taken to achieve pruning objectives while minimizing live branch loss and wound size.

Pruning of newly planted trees should be limited to the removal of dead or broken branches. All other pruning should be withheld until the second or third year, when a tree has recovered from the stress of transplanting.